So, progress continue on my sd qant...
First up, a led on the forehead. Drill a 3mm hole about the center and position the led like this...
Drill hole behind the head to let the led leg stick out for wiring
Next is for the eye
Position and drill a hole above the chin where the eye will cover the area like the picture below
And the leg of the eye led will come out under the chin
Lastly is the chest, the green piece is the gn drive that place into the middle of the chest, so i drill two parallel straight hole to allow the led to hold like this
Test fit into the chest, Sucess ....
That about it for the led, will proceed to paint and finish the model, stay tune....
No comments:
Post a Comment